寶馬維修這些基本知識

來源：http://www.philiprobert.com發布時間：2021-03-05 16:47:17

自檢測技術：無論在起動期間還是在行駛期間，BMW汽車多個系統都具有自動自檢測功能。如果某個系統內出現故障，則發動機起動后相應的燈不熄滅或在行駛期間又重新亮起。如何正確處理這些問題，請見下述說明：
Self detection technology: no matter during starting or driving, multiple systems of BMW car have automatic self detection function. If there is a fault in a system, the corresponding light will not go out after the engine starts or will light up again during driving. How to deal with these problems correctly, please refer to the following instructions:
1.蓄電池不再被充電，發電機三角帶損壞或發電機充電電路有故障。請與附近的BMW汽車服務部聯系。
1. The battery is no longer charged, the triangle belt of the generator is damaged or the charging circuit of the generator is faulty. Please contact the BMW service department nearby.
2.發動機機油壓力，立即停車并關閉發動機，檢查機油油位，如有必要添加機油，請與附近的BMW汽車服務部聯系。
2. Engine oil pressure, stop and shut down the engine immediately, check the oil level, if necessary, please contact the nearby BMW service department.
注意：如果發生這種情況，請不要繼續行駛，否則會因為動機潤滑不足而損壞發動機。

Note: if this happens, please do not continue to drive, otherwise the engine will be damaged due to insufficient lubrication.
3.制動液壓系統，手制動器已松開，但該燈亮起：檢查制動液液位。如果制動液液位過低且制動踏板行程明顯加長，則可能是兩個液壓制動回路中的一個發生了故障。請到附近的BMW汽車服務部進行檢查。此時可能需要較高的制動踏板力并且制動距離可能明顯加長。必須使您的駕駛行為適應制動性能變化的要求。
3. Brake the hydraulic system, the hand brake has been released, but the light is on: check the brake fluid level. If the brake fluid level is too low and the brake pedal travel is significantly longer, it is possible that one of the two hydraulic brake circuits has failed. Please go to the nearby BMW service department for inspection. A higher brake pedal force may be required and the braking distance may be significantly longer. You must adapt your driving behavior to the changing requirements of braking performance.
4.輪胎失壓顯示，同時伴有一個聲音報警信號：輪胎失壓。應降低速度并小心停車，避免激烈的制動和轉向操作。
4. Tire pressure loss display, accompanied by an audible alarm signal: tire pressure loss. Slow down and stop carefully to avoid intense braking and steering operations.
5.制動摩擦片狀態，說明摩擦片剩余厚度已經很少，請到BMW汽車服務部進行檢查。
5. The status of the brake friction plate indicates that the remaining thickness of the friction plate is very small. Please go to the BMW service department for inspection.
6.添加清洗液，清洗液液位過低，下次有機會時添加，清洗液的防凍劑是易燃的，因此防凍劑必須遠離火源，只能儲存在密閉的原裝容器內并存放在兒童無法拿取的地方。
6. Add the cleaning solution. The liquid level of the cleaning solution is too low. The antifreeze of the cleaning solution is flammable next time. Therefore, the antifreeze must be kept away from the fire source and can only be stored in a sealed original container and in a place where children can't get it.
7.動態穩定控制系統DSC和制動報警燈，指示燈閃爍：該系統進入工作狀態并控制驅動力和制動力。指示燈一直亮：DSC可能被關閉。出現故障時，請到BMW汽車服務部進行檢查。
7. Dynamic stability control system DSC and brake warning light, indicator light flashing: the system enters the working state and controls the driving force and braking force. Indicator always on: DSC may be off. In case of failure, please go to BMW service department for inspection.
8.添加冷凍液，冷卻液液位過低，下次有機會時添加。
8. Add refrigerant. The coolant level is too low. Add it next time.
9.安全氣囊指示燈，該指示燈表示，安全氣囊系統和安全帶拉緊裝置已進入功能準備就緒狀態。系統準備就緒：指示燈短時間亮起。系統有故障：指示燈不亮或指示燈持續閃爍。請到附近的BMW汽車服務部進行檢查。
9. Airbag indicator light, which indicates that the airbag system and safety belt tension device are ready for function. System ready: indicator lights up for a short time. System fault: indicator does not work or indicator flashes continuously. Please go to the nearby BMW service department for inspection.
有了濟南寶馬汽車維修上面的小總結，希望對廣大客戶有所幫助，如果有什么不理解的或者尋求幫助的請點擊我們的網站：http://www.philiprobert.com或者來電咨詢，我們會盡全力為您解決
With the summary of Jinan BMW car maintenance, I hope it can help our customers. If you have any questions that you don't understand or ask for help, please click our website: http://www.philiprobert.com call consultation, we will try our best to solve for you